Super Systems CarbCALC II - Manual (Page 19)

CarbCalcII CarbCalc II 18
© 2005,2006,2007 Super Systems Inc.
· Save Load - Click to save the Load in the database (does not select the load for execution)
· Select Load - Click to select the load for execution (also saves the load to the database)
2.6.2.1 Entering a Load
In the Control Mode, you may enter a new load and either "Save" it for later use or "Select" it for
current operations.
Steps to Enter and execute a Load in Realtime Control Mode
1. Select Realtime Mode (the run button changes to 'Load Entry")
2. Click on "Load Entry" to open the New Loads dialog
3. Select a Load and click on the Select Load button
4. The button changes from "Load Entry" to Start Recipe.
5. At this point you should verify the recipe, profile, material etc. You may switch to "Simulation"
and make simulation runs before starting the recipe in RealTime control.
6. Make sure the furnace is physically loaded.
7. Start the recipe. When the recipe is running, the computer is sending setpoints to the Carbon
and Temperature controllers. Ath this point, CarbCalcII and the CarbCalc computer are
dedicated to controlling the recipe. If you attempt to stop CarbCalcII you will get a warning
message.