Super Systems CarbCALC II User Manual
Page 28
CarbCalcII
CarbCalc II
27
© 2005,2006,2007 Super Systems Inc.
used to specify the data source values.
·
Chan. - select the SuperData channel from the dropdown.
·
Slot. - select the SuperData slot from the dropdown.
·
Default/Manual - enter a default value - this value is used in the model when communications is
lost, the value is also used as a manual input value when the data is not available and the channel
is set to "(None)".
·
Multiplier - SuperData data is always stored as integer with implied decimal points. e.g. 1.05 %C
would be stored as 105, For this reason, it is necessary to provide a multiplier to retrieve the
correct value. In the case of %Carbon, the multiplier is 0.01.
·
OK Button - saves the changes for the current furnace (you must save the furnace settings to
make these changes permanent)
·
Cancel Button - ignores any changes and exits the dialog.
·
·
Note: When in Control mode, you will also be prompted to supply the Setpoint Write
Locations.