Westermo IDW-90 AT - Manual (Page 4)

4 6620-3200
2. DIP-Switch Setup
The IDW-90 DIP-switches will be read at Power on and override the current
database setting.
If an AT-command or Configurator command given after Power on is addressing
the same parameter as a DIP-switch setting, the command will in turn override
the DIP-switch setting.
To store the current DIP-switch setting use the configurator command save or AT&W.
3. Factory settings
Throughout this manual the default factory settings of parameters are shown with bold
typeface and labelled (default) where applicable.