Westermo IDW-90 AT - Manual (Page 8)

8 6620-3200
A/ – Repeat last command line
This command repeats the commands of the last entered command line.
Note: No prefix AT is required.
A/
##An – Only analogue outgoing call
Forces the IDW-90 to make analogue calls even if no control character (’#’ or ’!’)
is used in the dial string.
This also implies that no digital outgoing call can be made when AT##A1 is set.
Digital incoming calls can still be received.
AT##A0: configures the adapter to be able to make both analogue
and digital outgoing calls. (default)
AT##A1: configures the adapter only to make analogue outgoing calls.
A – Accept incoming call
Using this command you can accept an incoming call, if automatic call acceptance is
not set (Register S0 = 0). An incoming call is displayed by the message “RING” or
the code “2”.
Must be the last command in an AT command line.
ATA
B – B channel protocol
This command will respond with OK without any functionality after it. The B-channel
protocol settings can be set with AT**prot.
%B – Set local baudrate
Sets the local baudrate of the IDW-90 to the desired value (fixed value) or to auto-
detection. When autodetection is set, the IDW-90 will recognize the desired baudrate
with every newly entered AT command by the terminal equipment (PC). With all other
settings the PC must use the same baudrate.
Must be the last command in an AT command line.
AT%B0 Automatic local baudrate detection enabled (autobauding, default)
AT%B1 Local baudrate set to 1 200 bit/s
AT%B2 Local baudrate set to 2 400 bit/s
AT%B3 Local baudrate set to 4 800 bit/s
AT%B4 Local baudrate set to 9 600 bit/s
AT%B5 Local baudrate set to 19 200 bit/s
AT%B6 Local baudrate set to 38 400 bit/s
AT%B7 Local baudrate set to 57 600 bit/s
AT%B8 Local baudrate set to 115 200 bit/s
AT%B9 Local baudrate set to 230400 bit/s
Note: Autobauding (AT%B0) is available for AT command set only.
If autobauding is selected and no AT-command has been sensed
before an incoming call baudrate 9600 will be used.