Westermo IDW-90 AT - Manual (Page 47)

47 6620-3200
bodit – BOD increase timer
bodit=<incrTime> Sets the time in seconds the bit-rate has to exceed the increase
value before the second B-channel is connected (default=30)
boddv – BOD decrease value
boddv=<decrValue> Sets the bit-rate in kbit/s at which the second B channel is
disconnected (default=40).
boddt – BOD decrease timer
boddt=<incrTime> Sets the time in seconds the bit-rate has to be below the
increase value before the second B-channel is disconnected
(default=30)
br – Baudrate asynchronous
Selection of the asynchronous baudrate for the DTE interface
0: Autobauding, (automatic local bit rate adaption) (default)
1: 1 200 bit/s
2: 2 400 bit/s
3: 4 800 bit/s
4: 9 600 bit/s
5: 19 200 bit/s
6: 38 400 bit/s
7: 57 600 bit/s
8: 115 200 bit/s
Note: Autobauding (br = 0) is available for AT command set only.
brn – Line baudrate asynchronous V.110
Selection of the asynchronous baudrate for V.110 line (B channel)
0: Line baudrate equals local baudrate (default)
1: 1 200 bit/s
2: 2 400 bit/s
3: 4 800 bit/s
4: 9 600 bit/s
5: 19 200 bit/s
6: 38 400 bit/s
bsize – Frame length
Maximum length of a data frame (default 2048)
Note! changing the B-channel protocol will affect the bsize parameter.
This setting is valid for both received and transmitted data frames.
prot=X.25-B 128
prot=X.31-D 128
prot=X.75 2048
values: 32 .. 2048