Westermo IDW-90 AT - Manual (Page 56)

56 6620-3200
subi – sub address for incoming calls
Own SUB (sub address) for incoming calls.
subi * global subi, all incoming calls will be accepted, (default).
subi nn set "subi" to nn = string of digits (max length = 22).
subi - no acceptance of incoming calls.
subi show current setting of "subi".
subo – sub address for outgoing calls
Own SUB (sub address) for outgoing calls.
subo nn set "subo" to nn = string of digits (max length = 22).
subo - no use of “SUB” value for outgoing calls, (default).
subo show current setting of "subo".
swstatus – TA-DIP Switches status
Returns the status of the TA-Configuration switches.
This command has the same function and result as ATI7 command.
See ATI7 command for presented result.
tdi – Timer delay incoming call
Delay time between receiving ISDN incoming data call and signalling via RING
or CONNECT message.
0: no delay (default)
1..n: delay time in 50 ms ticks. VAD är MAX n
tei – TEI value
X.31 D channel only:
Terminal equipment identifier. This value must be identical to the tei of your basic rate
access, will be defined by your ISDN supplier.
tei=1 (default)
trcnnn – commands for internal trace
The usage of the commands for internal trace are described in chapter 9.
txfwd – Timer for data forwarding
If no character is entered within the defined period, the received data will be transmitted
to the ISDN using the selected transmission protocol. (comparable to the functionality of
X.29 parameter 2, data forwarding timer)
0: minimum delay time (appr. 10 ms)
1..n: delay time in 50 ms ticks. (default: 1)
Note: Valid for AT command set and X.25 B channel or X.25 D channel only.