Westermo IDW-90 AT - Manual (Page 64)

64 6620-3200
<data1> The interpretation of this field depends on the service specified for
the entry. The field accepts 0 – 20 characters.
<data2> Interpretation of field <data2> is also service dependent the size
is 0 – 160 characters.
<data3> Field <data3> is only used for SMS and EMAIL service.
Service Function of <data1>
DIAL Number to connect to.
SMS Phone number of SMS receiver.
TEXT Phone number of TEXT receiver, if left empty the TEXT is sent out on the local
DTE connection.
EMAIL Reserved.
OUT Phone number of the modem where the output shall be set. If <data1>,
is empty the transfer will be to the local digital output.
CMD AT command string to be executed when the entry is triggered, can be used to
modify the trigger condition.
TRANS Phone number of the modem to which the transparent IO should occur.
For dependencies of other parameters and line type. See Table 5.
<data1> Makes a connection to the number defined and start
=number Transparent IO transfer between the two units.
<data1>=empty Transparent IO transfer will use an existing data connection.
Service Parameter <data2>
DIAL Not used
SMS The SMS message
TEXT Text message
EMAIL E-mail message
OUT A sequence of “101.. “ to be transferred to the addressed output
CMD Not used
TRANS Not used
Service Parameter <data3>
SMS SMS provider number.
EMAIL Reserved for ISP number