Westermo IDW-90 AT - Manual (Page 49)

49 6620-3200
cdsr – DSR control
DSR control
0: DSR always ON (default)
1: DSR indicates a connection
2: DSR follows DTR
See also 4.3 Serial status lines
cdtr – DTR control
Usage of DTR to control ISDN connection
0:-No control:
Incoming calls will be accepted independent of DTR status;
DTR drop does not disconnect an active connection.
2: DTR off disconnects (default)
Incoming calls will be accepted only when DTR is ON;
DTR drop disconnects an active connection.
4: DTR is evaluated:
Incoming calls will be accepted independent of DTR
status; DTR drop disconnects an active connection
See also 4.3 Serial status lines
chappwd – Set password for PPP chap authorisation
(only required for WINDOWS 95)
Enable ML-PPP CHAP authorisation by setting the password corresponding to the user
name used for the PPP connection. If the server does not handle CHAP an automatic
fallback to PAP is performed.
chappwd=<password> set password for CHAP
Note: Since the password is shown in plain text it may be disclosed by unauthorised
persons.
cipm – cip value mask
Selects the bearer services that can be accepted with an incoming call. The definition
of hbhbhbhb (double word) is the CIP mask as defined in the CAPI 2.0 specification
(default 00010016h).
Example: cipm=00010016: Accept analogue incoming calls
cipm=00000001: Accept all incoming calls.
See also AT command AT#C1.
cipo – cip value outgoing
Selects the bearer service that will be sent with an outgoing call.
The value for hbhb (word) is the CIP value as defined in the CAPI 2.0 specification
(default 0002h).
Example: An outgoing call as a voice call: cipo =0004.
See also AT command AT#C2.