Westermo IDW-90 AT - Manual (Page 46)

46 6620-3200
acctab – isdn access control
Using these commands a table can be set up which allows only dedicated callers to get a
connection to the TA.
acctabx nn/ss set entry number x to ISDN number nn and subaddress ss
acctabx - clear entry number x
acctabx * Allow all incoming calls to be accepted
acctabx show entry number x
acctab Show all entries
Note: for a detailed description see section ”ISDN access control” on page 39
atsx, atopt, atrej – AT command parameter set
AT command set only:
Handle AT specific settings.
Show and change AT S registers by entering the new value.
ats0 show setting of S0-Register
ats0=1 set Register S0 to 1
atopt show option register (bit-values):
bit 0 : 01 => ATV1
bit 1 : 02 => ATW1
bit 2 : 04 => ATQ1
bit 3 : 08 => ATE1
bit 4 : 10 => ATS9=0
atrej show reject register => setting of AT#R (0,1)
autoreset – TA reset option
The autoreset command has a default value of 0, but if the value is 1 then the unit will
reset every time a disconnect occurs.
If the value is more that 1 and less that 255 the unit resets periodically by the number of
minutes specified by this command.
Example: autoreset=0 (default)
autoreset=1
autoreset=20
bc – Bearer capability
Bearer capability for outgoing data calls.
bc = 0000 (default)
bod – Bandwidth On Demand enable
0 disable BOD (default)
1 enable BOD
bodiv – BOD increase value
bodiv=<incrValue> Sets the bit-rate in kbit/s at which a second B channel
is connected (default=40).