Alinco DJ-A10 - Manual (Page 20)

Professional
FM Transceiver
02
You may set the radio as VFO mode and Channel mode. There are also different setting parameters to
properly set functions as per your operating comfort.
OPERATION MODE (VFO mode and Channel mode)
1. By programming software:
In PC programming utility software, "General Setting" menu, choose "Display Mode" to select VFO
mode or Channel mode.
2. By manual setup:
Please refer to "Display Mode" in Page 51.
VFO Mode: In this mode, press【D】key to switch between Channel mode and VFO.
A.Frequency + Channel mode: At this mode, when set display as "FREQ",
it enters into Frequency + Channel mode. Once the radio is turned off or
switched to another channel, the temporary setting will be erased and back to
initial settings. (As pic 1)
B.Channel + Name Tag Mode: When set display as "NAME", it enters into
Channel +Name Tag Mode. At this mode, it will display corresponding channel
name when the current channel is edited with name in advance. Otherwise,
it will display frequency and channel number. Its operations are the same as
frequency + channel mode. (As pic 2)
C.VFO Mode（Frequency mode): This mode shows only frequency on the
display. Set mode operation and Channel setting are stored as the latest
value. Once the radio is turned off or changed to new frequency using VFO,
the value remains until next change. (As pic 3)
(Pic 1)
(Pic 2)
(Pic 3)