Alinco DJ-A10 - Manual (Page 34)

Professional
FM Transceiver
16
INSTALLATION & CONNECTION
Installing / Removing the Belt Clip
Installing the Belt Clip:
1. Put the belt clip on the back of the unit, and the screw clockwise until it stops.
2. Confirm that the belt clip is securely attached.
* Tighten up the screw occasionally.
Removing the Belt Clip:
Turn the screw counter-clockwise to remove the belt clip.
Caution: Use the screws of specified size only. Others may cause
damage to the product. screws (+PM2.5x3)
Installing / Removing the Antenna
Installing the Antenna:
1. Hold the antenna by its base.
2. Align the grooves at the base of the antenna with the protrusions
on the antenna connector.
3. Slide the antenna down and turn it clockwise until it stops.
4. Confirm that the antenna is securely connected.
Removing the Antenna:
Turn the antenna counter-clockwise to disconnect the antenna.
UN LO CK
NOTE: Do not use third-party antenna as it may radiate more RF
that exceeds SAR limit guidances.