Eneo EDC-4222B - Manual (Page 12)

Figure 6 – Layout of Switches
2.3 Setting Dome Camera Termination
The device which is connected at end of line, whether it be a dome camera or keyboard
controller, must have the cable for communication terminated by setting the appropriate DIP
switch. Without proper termination, there is potential for control signal errors. Total length of the
cable for communication should not exceed 4000ft (1.2km).
SW1
o
n
SW1 SW1-1 SW1-2
Terminated ON ON
Not terminated OFF OFF
Figure 7 – Setting Dome Camera Termination
2.4 Fail-safe Network
When you control the dome by the other device not own keyboard, some error may be existed in
the serial communication. The reason is caused by the other device without the fail-safe network.
6