Eneo EDC-4222B - Manual (Page 32)

Use the Joystick to set the location of the start point(yellow mark). Move the cursor (green mark)
by pushing the Joystick, up, down, right or left. Select the location of the end point.
Draw a cross line to end point from start point.
5. Select the Exit (with saving) and push the Joystick to the right. Press ESC to exit the program
without saving.
Note : To minimize failure rate of “Cross”, you are recommended to draw horizontal Cross
line than vertical line. Also cross line should be placed on the position where object is
passing fast.
Note : Malfunction might occur or the cross will be deactivated if the moving object
reaches the edge of the Cross-line.
3.5.5 Area
You can detect a moving object that newly enters in a specified area (enter box).
You can see current status of moving object by “Bounding Box”.
(“Bounding box” means you can see a virtual rectangle on moving object. In prior of this, you
make sure that you set “On” in display and Bounding box in OSD Setup.
26