Eneo EDC-4222B - Manual (Page 40)

OFF - Shows activated alarms only.
Dwell : means the dwell time during multiple alarms, 03 to 99 seconds.
There are 8 levels of priority. The function can be selected by Preset, Auto scan, Pattern or Tour
and “0” is the highest priority. Lower priority alarms won’t be serviced until the higher priority
alarm is completed. Equal priority alarms will be serviced repeatedly with the dwell time.
The RELAY OUT setup is helpful when the outdoor housing is used with the dome.
Ex.) When you connect the relay output of the dome to the heater connector of the outdoor
housing, the relay output can operate during the setting time only.
Alarm: the relay output is operated during an alarm operation or by the short key of our keyboard.
1-5 MIN (minute): the relay output is operated during this setting time only by the function run of
the dome menu or the short key of our keyboard.
Note : This 1-5 MIN setting is not operated by an alarm.
Note : If you disable Alarm by dip switch, Alarm menu will be displayed following screen.
You can set the schedule of Alarm operation on this menu.
34