Eneo EDC-4222B - Manual (Page 14)

2.5 Setting Dome Camera Address (ID)
When the COMMUNICATION MODE is set to S/W
Dome camera address (ID) and Protocol can be used by selecting from the MENU
You can call up the On-screen menu utility on your monitor by pressing MENU key
on the keyboard controller, the following On-screen menu utility will appear:
Select the” DOME COMMUNICATION” and set the desired idem by twist the Joystick
See Chapter 3 — Program and Operation for DOME COMMUNICATION.
If you want to set the address more than 999, you should contact the service provider.
NOTE: C OMMUNICATION MODE is set to S/W, the Hardware (H/W) setting is ignored.
8