Eneo EDC-4222B - Manual (Page 52)

3.16 Home Function Setup
MODE : Home Function / Power On
FUNCTION : None/ Tour/ Pattern / Auto Scan / Preset
FUNCTION NUMBER : - - -
WAITING TIME : 10~240 Seconds
FUNCTION ENABLE : ON/ OFF
The Home function can be set so that the camera automatically goes to Preset, Tour, Pattern,
Auto Scan after the keyboard controller has been idle for certain time. For example, if the
controller is idle for 120 seconds, the camera goes to preset 1.
Power on mode, you can set the camera to go Preset, Tour, Pattern, Auto Scan in case of power
off or black out.
Follow these steps to program the Home position:
1. Select Mode by pushing the Joystick up or down to scroll through Home Function / Power On
2. Select Function by pushing the Joystick up or down to scroll through the None, Tour, Pattern,
Auto Scan or Preset functions.
3. Select Function Number and push the Joystick to the up or to the down. The recorded
function number will list.
4. Select WAITING Time and push the Joystick to the up or to the down to select from 10 to 240
seconds. (Activated on Home Function only)
5. Select Function Enable and turn to ON or OFF by pushing the Joystick to the up or to the
down.
46