H3C Technologies H3C S9800 Series Switches - Manual (Page 36)

28
Figure 35 Removing a filler panel
3. Unpack the power module and verify that the power module model is as required.
4. Correctly orient the power module, grasp the handle of the power module with one hand and
support its bottom with the other, and slide the power module slowly along the guide rails into the
slot until it has firm contact with the connectors on the backplane.
To avoid damage to the connector of the power module, insert the power module gently. If you
encounter resistance while inserting the power module, pull out the power module and insert it
again.