Testing connectivity – H3C Technologies H3C S9800 Series Switches User Manual
Page 52
Advertising
44
{
For information about how to connect an LC connector, see
{
For information about how to connect an MPO connector, see
.
Figure 53 Using an LC optical fiber connector to connect an SFP module
Figure 54 Using an MPO optical fiber connector to connect a QSFP module
4.
Verify the connection by examining the port LEDs.
For more information about the LEDs, see "
Testing connectivity
After you plug the switch into the network, use the ping or tracert command to test the network
connectivity. For more information about these commands, see H3C S9800 Switch Series Command
References.
Advertising