H3C Technologies H3C S7500E Series Switches - Manual (Page 142)

13-23
To do… Use the command… Remarks
Display the IPv6 TCP connection
status information
display tcp ipv6 status Available in any view
Display the IPv6 UDP connection
statistics
display udp ipv6 statistics Available in any view
Clear IPv6 neighbor information (for
distributed devices)
reset ipv6 neighbors { all | dynamic |
interface interface-type interface-number |
slot slot-number | static }
Available in user view
Clear IPv6 neighbor information (for
distributed IRF devices)
reset ipv6 neighbors { all | dynamic |
interface interface-type interface-number |
chassis chassis-number slot slot-number
| static }
Available in user view
Clear the specified PMTU values
reset ipv6 pathmtu { all | static |
dynamic}
Available in user view
Clear the statistics of IPv6 and
ICMPv6 packets (for distributed
devices)
reset ipv6 statistics [ slot slot-number ] Available in user view
Clear the statistics of IPv6 and
ICMPv6 packets (for distributed IRF
devices)
reset ipv6 statistics [ chassis
chassis-number slot slot-number ]
Available in user view
Clear all IPv6 TCP connection
statistics
reset tcp ipv6 statistics Available in user view
Clear the statistics of all IPv6 UDP
packets
reset udp ipv6 statistics Available in user view
IPv6 Configuration Example
Network requirements
z Host, Switch A and Switch B are directly connected through Ethernet ports. Add the Ethernet ports
into corresponding VLANs, configure IPv6 addresses for the VLAN interfaces and verify the
connectivity between them.
z The aggregatable global unicast addresses of VLAN-interface 2 and VLAN-interface 1 on Switch
A are 3001::1/64 and 2001::1/64 respectively.
z The aggregatable global unicast address of VLAN-interface 2 on Switch B is 3001::2/64, and a
route to Host is available.
z IPv6 is enabled for Host to automatically get an IPv6 address through IPv6 NDP, and a route to
Switch B is available.