H3C Technologies H3C S7500E Series Switches User Manual

Page 197

Advertising

15-40

# Configure an IPv4 address .

<SwitchA> system-view

[SwitchA] interface vlan-interface 100

[SwitchA-Vlan-interface100] ip address 10.1.1.1 255.255.255.0

[SwitchA-Vlan-interface100] quit

[SwitchA] interface vlan-interface 101

[SwitchA-Vlan-interface101] ip address 1.1.1.1 255.255.255.0

[SwitchA-Vlan-interface101] quit

# Create an interface named Tunnel 1.

[SwitchA] interface tunnel 1

# Configure an IPv4 address for interface Tunnel 1.

[SwitchA-Tunnel1] ip address 10.1.2.1 255.255.255.0

# Configure the tunnel encapsulation mode.

[SwitchA-Tunnel1] tunnel-protocol gre

# Configure the source address of interface Tunnel 1 to be the IP address of the VLAN interface.

[SwitchA-Tunnel1] source vlan-interface 101

# Configure the destination address for interface Tunnel 1.

[SwitchA-Tunnel1] destination 2.2.2.2

[SwitchA-Tunnel1] quit

# Create service loopback group 1, setting the service type to tunnel.

[SwitchA] service-loopback group 1 type tunnel

# Add interface GigabitEthernet 2/0/3 to service loopback group 1.

[SwitchA] interface GigabitEthernet 2/0/3

[SwitchA-GigabitEthernet2/0/3] undo stp enable

[SwitchA-GigabitEthernet2/0/3] port service-loopback group 1

# Apply service loopback group 1 to the tunnel in tunnel interface view.

[SwitchA-GigabitEthernet2/0/3] quit

[SwitchA] interface tunnel 1

[SwitchA-Tunnel1] service-loopback-group 1

[SwitchA-Tunnel1] quit

# Configure a static route from Switch A through interface Tunnel 1 to Group 2.

[SwitchA] ip route-static 10.1.3.0 255.255.255.0 tunnel 1

2) Configure Switch B

# Configure an IPv4 address.

<SwitchB> system-view

[SwitchB] interface vlan-interface 100

[SwitchB-Vlan-interface100] ip address 10.1.3.1 255.255.255.0

[SwitchB-Vlan-interface100] quit

[SwitchB] interface vlan-interface 101

[SwitchB-Vlan-interface101] ip address 2.2.2.2 255.255.255.0

[SwitchB-Vlan-interface101] quit

# Create an interface named Tunnel 1.

[SwitchB] interface tunnel 1

# Configure an IPv4 address for interface Tunnel 1.

[SwitchB-Tunnel1] ip address 10.1.2.2 255.255.255.0

# Configure the tunnel encapsulation mode.

[SwitchB-Tunnel1] tunnel-protocol gre

Advertising

This manual is related to the following products:

H3C S5800 Series Switches, H3C S5120 Series Switches, H3C WA2600 Series WLAN Access Points, H3C WA2200 Series WLAN Access Points

Popular Brands

Popular manuals