H3C Technologies H3C S7500E Series Switches - Manual (Page 97)

9-7
Configuration procedure
z Before performing the following configuration, make sure that the Switch and the host are
accessible to each another via available routes, and the IP addresses of the interfaces are
configured as shown Figure 9-4 .
z This configuration may vary with different DNS servers. The following configuration is performed
on a Windows server 2000 PC.
1) Configure the DNS server
# Enter the DNS server configuration page.
Select Start > Programs > Administrative Tools > DNS.
# Create zone com.
As shown in Figure 9-5 , right click Forward Lookup Zones, select New zone, and then follow the
instructions to create a new zone named com.
Figure 9-5 Create a zone
# Create a mapping between host name and IP address.