H3C Technologies H3C WX5500E Series Access Controllers - Manual (Page 151)

140
Step Command Remarks
9. Configure the uplink port for
the isolate-user-VLAN.
a. Enter Layer 2 Ethernet or
aggregate interface view:
interface interface-type
interface-number
b. Configure the port to
operate in promiscuous
mode in a specific VLAN
or a list of VLANs:
port isolate-user-vlan
vlan-id promiscuous
Or
port isolate-user-vlan
vlan-list trunk
promiscuous
By default, a port does not operate
in promiscuous mode or host mode
in a VLAN.
10. Return to system view. quit N/A
11. Configure a downlink port for
the isolate-user-VLAN.
a. Enter Layer 2 Ethernet or
aggregate interface view:
interface interface-type
interface-number
b. (Optional.) Configure the
link type of the port:
port link-type { access |
hybrid | trunk }
c. Assign the port to
secondary VLANs (use
one of the commands
depending on the link
type):
port access vlan vlan-list
Or
port trunk permit vlan
{ vlan-list | all }
Or
port hybrid vlan vlan-list
{ tagged | untagged }
d. Configure the port to
operate in host mode:
port isolate-user-vlan host
By default, a port is an access port
that does not operate in host mode
or promiscuous mode.
12. Return to system view. quit N/A
Displaying and maintaining isolate-user-VLANs
Task Command Remarks
Display the mapping between an
isolate-user-VLAN and its secondary
VLANs.
display isolate-user-vlan
[ isolate-user-vlan-id ] [ | { begin |
exclude | include } regular-expression ]
Available in any view.