H3C Technologies H3C WX5500E Series Access Controllers - Manual (Page 218)

207
Local VLANs :
1(default),
The output shows that: port GigabitEthernet 1/0/1 has learned VLAN 1 and dynamic VLAN 20
created on Device B through MVRP; port GigabitEthernet1/0/2 has learned only VLAN 1 through
MVRP.
2. Change the registration mode and verify the configuration.
Set the MVRP registration mode to fixed on GigabitEthernet 1/0/3 of Device B, so that the
dynamic VLANs that Device B learns in VLAN 1 are not de-registered.
# Set the MVRP registration mode to fixed on GigabitEthernet 1/0/3.
[DeviceB] interface gigabitethernet 1/0/3
[DeviceB-GigabitEthernet1/0/3] mvrp registration fixed
[DeviceB-GigabitEthernet1/0/3] quit
# Display the local MVRP VLAN information on GigabitEthernet 1/0/3.
[DeviceB] display mvrp running-status interface gigabitethernet 1/0/3
-------[MVRP Global Info]-------
Global Status : Enabled
Compliance-GVRP : False
----[GigabitEthernet1/0/3]----
Config Status : Enabled
Running Status : Enabled
Join Timer : 20 (centiseconds)
Leave Timer : 60 (centiseconds)
Periodic Timer : 100 (centiseconds)
LeaveAll Timer : 1000 (centiseconds)
Registration Type : Fixed
Local VLANs :
1(default), 10,
The output shows that the VLAN information on GigabitEthernet 1/0/3 is not changed after you
set the MVRP registration mode to fixed on GigabitEthernet 1/0/3.
# Delete VLAN 10 on Device A.
[DeviceA] undo vlan 10
# Display the local MVRP VLAN information on GigabitEthernet 1/0/3.
[DeviceB] display mvrp running-status interface gigabitethernet 1/0/3
-------[MVRP Global Info]-------
Global Status : Enabled
Compliance-GVRP : False
----[GigabitEthernet1/0/3]----
Config Status : Enabled
Running Status : Enabled
Join Timer : 20 (centiseconds)
Leave Timer : 60 (centiseconds)
Periodic Timer : 100 (centiseconds)
LeaveAll Timer : 1000 (centiseconds)
Registration Type : Fixed
Local VLANs :