H3C Technologies H3C WX5500E Series Access Controllers - Manual (Page 190)

179
• If the LLDPDU transmit delay is greater than the LLDPDU transmit interval, the device uses the
LLDPDU transmit delay as the transmit interval.
Configuration procedure
To change LLDP parameters:
Step Command Remarks
1. Enter system view. system-view N/A
2. Set the TTL multiplier. lldp hold-multiplier value
Optional.
The default setting is 4.
3. Set the LLDPDU transmit
interval.
lldp timer tx-interval interval
Optional.
The default setting is 30
seconds.
4. Set the LLDPDU transmit delay. lldp timer tx-delay delay
Optional.
The default setting is 2 seconds.
5. Set the number of LLDPDUs
sent each time fast LLDPDU
transmission is triggered.
lldp fast-count count
Optional.
The default setting is 3.
Setting an encapsulation format for LLDPDUs
LLDPDUs can be encapsulated in the following formats:
• Ethernet II encapsulation—An LLDP port sends LLDPDUs in Ethernet II frames and processes only
incoming Ethernet II encapsulated LLDPDUs.
• SNAP encapsulation—An LLDP port sends LLDPDUs in SNAP frames and processes only incoming
SNAP encapsulated LLDPDUs.
By default, Ethernet II frames encapsulate LLDPDUs. If neighbor devices encapsulate LLDPDUs in SNAP
frames, configure the encapsulation format for LLDPDUs as SNAP to guarantee normal communication
with neighbors.
LLDP-CDP packets use only SNAP encapsulation.
To set the encapsulation format for LLDPDUs to SNAP:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter Ethernet interface
view or port group view.
• Enter Layer 2 Ethernet interface view:
interface interface-type interface-number
• Enter port group view:
port-group manual port-group-name
Use either command.
3. Set the encapsulation
format for LLDPDUs to
SNAP.
lldp encapsulation snap
By default, Ethernet II
encapsulation format
applies.