H3C Technologies H3C SecPath L1000-A Load Balancer - Manual (Page 24)

16
The L1000-A has SFP fiber ports, which only support LC connectors. The procedures for connecting SFP
fiber ports are similar. The following uses the SFP port as an example.
To connect a fiber port to a peer device through optical fibers:
1. Remove the dust plug from the fiber port.
2. Remove the dust cover from the transceiver module, and plug the end without a pull latch into the
SFP port.
3. Remove the dust cover from the fiber connector.
4. Identify the Rx and Tx ports. Plug the LC connector at one end of one fiber cable into the Rx port
of the L1000-A and the LC connector at the other end into the Tx port of the peer device. Plug the
LC connector at one end of another fiber cable into the Tx port of the L1000-A and the LC
connector at the other end to the Rx port of the peer device.
Figure 13 Connecting the fiber port
5. View the LINK LED after connection.
{
On means a link is present.
{
Off means no line is present. Try to change the Rx and Tx ends of the fiber. For more
information about the LEDs, see "
Appendix B LEDs ."
Connecting a power cord
Connecting an AC power cord
Before connecting an AC power cord, make sure the L1000-A is correctly grounded.
To connect an AC power cord:
1. Pull the bail latch leftwards.
2. Connect one end of the AC power cord supplied with the power module to the power receptacle
on the power module.
3. Pull the bail latch rightwards to secure the plug to the power receptacle.
4. Connect the other end of the power cord to an AC power outlet.