H3C Technologies H3C SecPath L1000-A Load Balancer - Manual (Page 46)

38
Replacing a transceiver module
WARNING!
•
When you remove a transceiver module, do not touch the golden finger on the module.
• Do not stare at the fibers to avoid hurting your eyes.
• Make sure the transceiver modules at the two ends of a fiber are the same type.
To replace a transceiver module:
1. Pressing the tab of the LC connector, pull out the LC connector from the transceiver module.
Put on the dust cap for the LC connector.
2. Pivot the clasp of the transceiver module down to the horizontal position.
3. Hold the clasp to pull the transceiver module out of the socket.
4. Put the dust plug on the removed module, and put the removed module into its original shipping
materials.
5. Install a new transceiver module.
For the installation procedures, see "
Connecting a fiber port ."
Figure 36 Removing a transceiver module
Replacing a power module
The methods for removing AC and DC power modules are similar. The following describes how to
remove an AC power module.
To replace a power module:
1. Face the rear panel of the L1000-A.
2. Unplug the power cord on the power module to be removed, and loosen the captive screws on
the power module with a Phillips screwdriver.
3. Supporting the bottom of the power module with one hand, and holding the handle of the power
module with the other hand, gently pull the power module out along the slide rails.