Configuring an ip address for the interface – H3C Technologies H3C SecPath L1000-A Load Balancer User Manual
Page 39
31
Item Description
User Privilege Level
Set the user privilege level of a user.
User privilege levels are visitor, monitor, configure, and management in
ascending order. A user with a higher level has all the operating rights of a user
with a lower level.
•
Visitor—Users of this level can perform ping and traceroute operations, but
cannot access the device data or configure the device.
•
Monitor—Users of this level can only access the device data but cannot
configure the device.
•
Configure—Users of this level can access data from the device and configure
the device, but they cannot upgrade the host software, add, delete, or modify
users, or back up or restore the application file.
•
Management—Users of this level can perform any operations for the device.
IMPORTANT:
The user privilege levels apply only to Web, FTP, Telnet, and SSH users.
Service Type
Set the service type that a user can use, including Web, FTP, SSH, Telnet, and
terminal.
You must configure a service type for each user for local authentication.
Otherwise, user authentication fails.
Password
Set and confirm the password. The confirm password must be the same as the
previously set password.
Any leading spaces in the password are ignored.
Confirm Password
Password Encryption
Specify the password encryption method:
•
Reversible—The device encrypts user passwords with a reversible encryption
algorithm.
•
Irreversible—The device encrypts user passwords with an irreversible
encryption algorithm.
Virtual Device
Set the virtual device to which a user belongs.
Every time a user logs in through the Web interface, the user logs in to the virtual
device to which the user belongs. When a root virtual device user with privilege
level Configure or Management logs in to the device, the user can log in to
another virtual device by selecting System > Device > Virtual Device > Virtual
Device. The access right of the user is the same as other virtual device users that
have the same privilege level.
Configuring an IP address for the interface
1.
Select System > Interface from the navigation tree.