H3C Technologies H3C SecPath L1000-A Load Balancer - Manual (Page 54)

46
Task Command Remarks
Display the current alarm
information of the transceiver
module in a specified interface.
display transceiver alarm interface
[ interface-type interface-number ] Available for all
transceiver modules.
Troubleshooting system exceptions
Configuring the exception handling methods
You can use one of the following methods to handle system exceptions:
• reboot—The L1000-A reboots to recover from the error condition.
• maintain—The L1000-A stays in the error condition and does not take any measure to recover
itself, so you can collect complete data, including error messages, for diagnosis.
To configure the exception handling method:
Step Command Remarks
Enter system view. system-view N/A
Configure the exception handling
method for the system. system-failure { maintain |
reboot }
Optional.
By default, the system uses the reboot
method when an exception occurs.
Displaying the exception handling method
Use the display system-failure command to display the exception handling method.
<H3C> display system-failure
System failure handling method: reboot
Rebooting your L1000-A
You can reboot the L1000-A in one of the following ways to recover from an error condition:
• Reboot the L1000-A immediately at the command line interface (CLI).
• At the CLI, schedule a reboot to occur at a specific time and date or after a delay.
• Power off and then re-power on the L1000-A. This method, also known as hardware reboot or cold
reboot, might cause data loss, and is the least preferred method.
IMPORTANT:
•
Specify the main system software image file before you use the reboot command to reboot the
L1000-A.
• For data security, if you are performing file operations at the reboot time, the system does not reboot.
The precision of the rebooting timer is 1 minute. One minute before the rebooting time, the L1000-A
prompts "REBOOT IN ONE MINUTE" and reboots in one minute.