Bang & Olufsen BeoVision 10 User Guide - Manual (Page 29)

29
You can extend your television into
a surround sound system by adding
Bang & Olufsen loudspeakers and a
BeoLab subwoofer.
When you switch on one of the
sources, the television automatically
selects the appropriate speakers,
depending on what kind of sound
suits the source you are using.
The speaker combination is optimised if
you press the centre button on Beo4.
NOTE! If you have added only two front
speakers to the TV, you will only be able
to choose SPEAKER 1–3.
Daily use of speaker combinations
– BeoVision 10-40/46
You can select the speaker combination
that suits the source you are using,
provided that the various speaker
modes are available in your television.
> Press LIST and use the navigation button
up or down to bring up SPEAKER in the
Beo4 display (Beo6: Press to bring up
the Scene display on Beo6, then press
Speaker to bring up the Speaker display).
> Press the centre button, if you want to
optimise the sound, or press 1 – 5 to
select the speaker combination you want.
(Beo6: Press Optimise or Mode 1 – 5).
The selected speakers cut in automatically.
> Press and hold BACK to remove the
SPEAKER from the Beo4 display and
return to the source you were using.
(Beo6: Press to remove the Speaker
display).
Adjust speaker balance with
Beo4
You can temporarily adjust the balance
between the speakers.
> Press LIST and use the navigation button
up or down to bring up SPEAKER in the
Beo4 display and press the centre button.
> Now use , , and to adjust the
speaker balance front, back, left and right.
> Press and hold BACK to remove SPEAKER
from the Beo4 display and return to the
source you were using.
SPEAKER 1
SPEAKER 1
SPEAKER 2
SPEAKER 3
SPEAKER 4
SPEAKER 5
Select speakers for movie sound