Eclipse - Fujitsu Ten AVX5000 - Manual (Page 154)

153
I
II
III
IV
V
VI
VII
VIII
IX
X
XI
XII
XIII
XIV
XV
XVI
XVII
XVIII
XIX
First, cancel the existing Key CD.
● Refer to “How to cancel the key CD”.
Next, program a new Key CD.
● Refer to “How to program the Key CD”.
If power is disconnected while ESN security is active (a Key CD was programmed), operation
is disabled until power is restored and the unit unlocked. Follow this procedure to resume
normal operation.
When the power is turned on after disconnecting the battery power, a
“SECURITY” message will appear for 2 seconds.
Insert your Key CD.
● If the correct CD is inserted, “The security lock was unlocked.” message will appear for
two seconds and the CD will begin playing.
How to change the Key CD
How to resume normal operation (ESN security lock out)
●If the incorrect CD is inserted, an “ERROR” (“ERROR” and error number)
message will appear for 2 seconds, after which the CD will be ejected.
●If “ERROR5” (the 5th time an error has occurred) appears, “HELP” will appear,
after which the CD will be ejected. When “HELP” appears, carry out the
operations for an ESN security lock out by following the procedure in “What
happens if an incorrect CD is inserted?” on next page.
●You must be use the same CD used for Key CD programming; a duplicate CD
may not work properly.