Eclipse - Fujitsu Ten AVX5000 - Manual (Page 193)

192
Adjusting sound quality
How to operate the optional 5.1ch decoder & AV selector unit
Touch , , ,
or to select the speaker
to be adjusted.
Touch to select the cut-off
frequency.
● Each time this switch is touched, the
cut-off frequency will be changed in the
following order shown below.
Front/Center/ Rear (Hz):
Woofer (Hz):
Touch to select the
slope.
● Each time this switch is touched, the
slope will be changed in the following
order shown below.
● Touch after making settings.
The X-Over mode adjustments will be
saved and system will return to the
previous operation screen.
Front Center Rear
Woofer
Freq
100 125 160 200 250
315 400 500 630 800
1k 1.25k 1.6k 2k 2.5k
3.15k 4k 5k 6.3k 8k
10k 12.5k 16k 20k
20 25 31.5 40 50 63
80 100 125 160 200
250
SLOPE
PASS 6 dB/oct 12 dB/oct
18 dB/oct 24 dB/oct
BACK
If no woofer has been connected, set the slope adjustment to “PASS”. (If slope is
set to a setting other than PASS, the low frequency range will not be outputted
from the speakers.