Eclipse - Fujitsu Ten AVX5000 - Manual (Page 224)

223
I
II
III
IV
V
VI
VII
VIII
IX
X
XI
XII
XIII
XIV
XV
XVI
XVII
XVIII
XIX
●The actual position and distance of people or objects may vary depending on the
features of the camera lens.
●Do not expose the camera to strong shocks such as hitting it or knocking it into
other objects. The Back-eye Camera may not function properly if the position of
the camera or its mounting angle is incorrect.
●The camera is waterproof. Do not uninstall, dismantle or reconfigure the unit.
Otherwise, the Back-eye Camera may not function properly.
●If the camera cover is rubbed strongly or a hard brush or abrasive is used to
clean it, the camera may get scratched, adversely affecting the image quality.
●The camera cover is made of plastic. Do not apply organic solvent, body wax, oil
remover, glass coating, etc. to it. If any of the above have been applied, wipe off
immediately.
●Pouring hot water on the Back-eye Camera to deice it in cold weather can lead to
a drastic change in temperature that may render normal operation impossible.
●The Back-eye Camera may not operate normally if the camera is damaged as a
result of it being hit. Immediately bring it to your local retailer for an inspection.
●Do not leave the unit in direct sunlight for long periods of time. Otherwise, a
printed image phenomenon may result.
●The range appearing on the monitor screen varies depending on the vehicle
model.
●The instant the vehicle is put in reverse, part of the monitor will appear white then
gradually stabilize.
●A white vertical band will appear when the camera is struck by light from the sun,
headlights or any other strong light beam source (Smear effect).
●After having used the Back-eye Camera for a long time, white scratches and
vertical lines may appear due to a rise in temperature, depending on the features
of the CCD.
●The 50 Hz power source range fluorescent light may cause flickering in the
screen. This is not a malfunction.
●Because the Back-eye Camera uses a special lens, the image and distance
appearing on the screen differs from the actual image and distance.