Woofer output setting, Crossover adjustment (x-over), Adjusting sound quality – Eclipse - Fujitsu Ten AVX5000 User Manual
Page 65
64
Basic operation
Adjusting sound quality
Woofer Output can be stereo or mono. Select the method that matches the output method for
the sub-woofer system that is connected to the unit.
Touch
to select
STEREO or MONO.
● Touch
after making changes.
The woofer output setting will be saved
and system will return to the previous
operation screen.
The frequencies for the front and rear speaker high-pass filter (HPF) and woofer low-pass filter
(LPF) can be set within a range of 63 to 200 Hz. (This is the same as the HPF and LPF cutoff
frequencies.)
Touch
to select the cut-off
frequency.
● Each time the switch is touched, the
frequency will be changed in the
following order shown below.
Woofer output setting
Woofer OUT
BACK
Crossover adjustment (X-Over)
Freq
63Hz 80Hz 100Hz 125Hz 160Hz 200Hz