Extron electronic MEDIALINK MLC 52 - Manual (Page 34)

Operation, cont’d
MLC 52 Series MediaLink Controllers • Operation 3-6
1 1
2
3
4
E
ON
2 3 4
Tx IR OUT GND IR IN GND + 12V
1 1
2
3
4
E
ON
2 3 4
Tx IR OUT GND IR IN GND + 12V
Less Than 6”
IR Beaming
Transmitting MLC
Receiving MLC
1
ON
2 3 4
1
ON
2 3 4
Setting up transmitting and receiving units for wireless data transfer
The data transfer begins when the receiving unit detects the transmitting unit,
and the process takes 15 to 20 seconds to complete. (It may take longer if the
transmitting unit has multiple commands programmed on each button.)
The front panel buttons act as data transfer progress indicators. While data is
being transferred, the buttons on both the transmitting and the receiving
MLCs blink sequentially in clockwise order, starting with the On button in the
upper-left corner (see the diagram below). This cycle repeats until transfer is
complete.
MLC 52
DISPLAY
ON
PC
OFF
VOL
VOL VIDEO
MLC 52
VOLUME
DISPLAY
ON
PC
OFF
VCR
DVD
Order in which the buttons blink during data transfer