Special applications, cont’d – Extron electronic MEDIALINK MLC 52 User Manual
Page 58
Special Applications, cont’d
MLC 52 Series MediaLink Controllers • Special Applications
4-14
Programming video inputs — projector remote control type B
1
.
Place the rear panel configuration DIP switch #1 in the On (up)
position to enable learning mode. (If the MLC is already in
learning mode, proceed to step 2.)
2
.
Using IR learning, program command “A” from the Video input selection
button on the projector’s remote control into memory block #1 of the
MLC 52’s Video or blank (for VC models) button as follows:
a
.
Press the Video button on the MLC front panel. The button blinks,
indicating that the MLC is ready to learn the command. On the rear
panel, the bottom IR learning LED flashes.
b
.
Within 5 seconds (while the Video button on the MLC 52 is blinking),
press the Video button on the projector’s remote control. The MLC has
learned command “A” for Video.
When a command has been successfully learned, the IR learning LEDs on the
MLC rear panel flash in rapid progression from the top to the bottom, then
back to the top.
3
.
Program the input selection command “B” from the Video input selection
button on the projector’s remote control into memory block #2 of the
MLC 52’s Video button as follows:
a
.
Press the Video button on the MLC front panel. The button blinks,
indicating that the MLC is ready to learn the command. On the rear
panel, the second LED from the bottom flashes.
b
.
Within 5 seconds (while the Video or blank button on the MLC 52 is
blinking), press the Video button on the projector’s remote control. The
MLC has learned command “B” for Video.
4
.
When finished programming the MLC 52 buttons, return configuration DIP
switch #1 to its Off (down) position.
5
.
Test the system.
MLC 52
DISPLAY
ON
PC
VIDEO
OFF
VOL
VOL
Command #1: RGB / IR Command “A”
Command #2: RGB / IR Command “B”
Command #1: Video / IR Command “A”
Command #2: Video / IR Command “B”
SIZE
ENTER
MENU
CENTER
CONT/
BRT
COL/
TINT
ASPECT
RATIO
VIDEO
MUTE
AUDIO
MUTE
A/V
MUTE
SHARP
PHASE
VIDEO
COMPUTER
Projector Remote Type B
Programming MLC 52 input selection buttons from a projector remote
control type B
1
ON
2 3 4