Extron electronic MEDIALINK MLC 52 - Manual (Page 82)

Serial Communication, cont’d
MLC 52 Series MediaLink Controllers • Serial Communication 5-22
After a few seconds, the Extron MLC 52 Configuration Program main
screen appears, displaying a graphic representation of your selected model
and of the IR 452 remote control.
The MLC 52 Configuration Program screen (not configured)
If you have loaded any configurations to your MLC previously, the most
recently saved configuration is displayed, including button switch mode
colors and name labels, driver commands, and display device settings.
The color of each button on the screen reflects the button’s switch mode. If
you open the configuration software through the wizard, the buttons’ switch
modes are set according to the configuration you just created via the wizard.
If you open the software without going through the wizard, and no
configuration has been loaded to the MLC, the screen buttons are the factory
defaults colors (See “Factory defaults” on page 5-37).
6 . Create a configuration for your MLC as described in the following sections.
• If you want to base the new configuration on an existing one, restore
the desired configuration. (See “Restoring a configuration,” later in
this chapter.) You can then modify it as desired and save it under a
new name, as discussed in the following sections.
• If you want to create a completely new configuration, and a
configuration has already been loaded to your MLC, reset the
controller to its factory defaults. (See “Resetting” on page 5-47.)