Extron electronic MEDIALINK MLC 52 - Manual (Page 75)

5-15 MLC 52 Series MediaLink Controllers • Serial Communication
Assign Commands To Buttons window with PC button selected
To add a command to a button,
a . Click on the screen button that you want to program. A yellow box
appears around it, and its name is displayed in the Selected Button
field. In the illustration above, the button labeled “PC” was selected.
b . In the Select Driver Command field, click on the command function
you want the selected button to execute. In the illustration, RGB1 was
selected.
c . Click Add Command. The selected
command appears in the next available slot
in the Assigned Driver Commands field,
replacing <EMPTY>. See the example at
right.
d . If you want to add another command to the
same button, repeat steps 5b and 5c. You
can assign up to four commands to a
button.
e . If you want to assign commands to another
button, repeat steps 5a through 5d for each
button that you want to program.
If you do not want to add a command to a button at this time, click Skip to
go to the next screen.
To remove a command from a button,
a . Click on the button from which you want to remove the command.
b . In the Assigned Driver Commands field, click on the command
function that you want to remove.
c . Click Remove Command. The command name is replaced by
<EMPTY> in the Assigned Driver Commands field.