Emerson 3081FG - Manual (Page 35)

Instruction Manual
IB-106-3081 Rev. 1.5
September 2002
Rosemount Analytical Inc. A Division of Emerson Process Management Startup and Operation 3-5
Model 3081FG
d. Navigation
The IRC in Figure 3-6 is used to interact
with the Model 3081 Transmitter and navi-
gate through the screens on the LCD.
1. Hold the IRC within 6 ft (1.8 m) of the
Model 3081 Transmitter and within 15
degrees from the centerline of the
transmitter LCD. The amount of ambi-
ent light may also affect IRC
performance.
NOTE
The LCD may react slowly to IRC
commands. Allow sufficient time be-
tween key presses to avoid undesired
or repeated commands from accumu-
lating in the command queue.
2. Use the keys on the IRC to navigate
through the menu screens. Refer to
Figure 3-6. General usage is as
follows:
(a) RESET. Returns to the PROCESS
DISPLAY screen at the top of the
menu tree. Any non-entered num-
ber in the exited state will be ig-
nored, and the previous data will
be used.
(b) HOLD. Not used.
(c) Left/Right Arrow. Moves left and
right among editable digits on the
display.
(d) Up/Down Arrow. Increases or de-
creases the value of the currently
selected digit on the display.
(e) CAL. Accesses the CALCHECK
MENU branch of the menu tree.
Only works from the PROCESS
DISPLAY screen.
(f) PROG. Accesses the PROGRAM
MENU branch of the menu tree.
Only works from the PROCESS
DISPLAY screen.
(g) DIAG. Accesses the DIAGNOS-
TICS MENU branch of the menu
tree. Only works from the PROC-
ESS DISPLAY screen.
(h) ENTER. Initiates the editing proc-
ess and causes the most signifi-
cant digit of the edited item to start
flashing. Also processes the entry
so the previous value updates to
the new value entered using the ar-
row keys. Failure to press ENTER
before exiting a screen will cancel
the input value and revert to the
previous value.
(i) NEXT. Accesses the next user
screen as shown in the menu tree.
Any non-entered number in the ex-
ited state will be ignored, and the
previous data will be used.
(j) EXIT. Exits from sub-branches of
the menu tree where an exit option
is explicitly shown. Otherwise, re-
turns to the PROCESS DISPLAY
screen at the top of the menu tree.
Any non-entered number in the ex-
ited state will be ignored, and the
previous data will be used.
RESET HOLD
ENTER CAL
PROG
DIAG EXIT
NEXT
FISHER-ROSEMOUNT
ROSEMOUNT
MODEL 3081
REMOTE CONTROL
26020032
Figure 3-6. Infrared Remote Control (IRC)
3