Precision Digital PD6310 - Manual (Page 22)

Model PD6210 & PD6310 Batch Controllers Instruction Manual
22
Transmitter Supply Voltage Selection (P+, P-)
All controllers, including models equipped with the 12/24 VDC power
option, are shipped from the factory configured to provide 24 VDC
power for the transmitter or sensor.
If the transmitter requires 5 or 10 VDC excitation, the internal jumper
J4 must be configured accordingly.
To access the voltage selection jumper:
1. Remove all the connectors.
2. Unscrew the back cover.
3. Slide the back cover about 1 inch.
4. Configure the J4 jumper, located behind the input signal connector,
for the desired excitation voltage as shown.
Figure 5: Transmitter Supply Voltage Selection
6000SensorExcitation
Connections
All connections are made to removable screw terminal connectors
located at the rear of the controller.
!
Caution!
Use copper wire with 60°C or 60/75°C insulation for
all line voltage connections. Observe all safety
regulations. Electrical wiring should be performed in
accordance with all applicable national, state, and
local codes to prevent damage to the controller and
ensure personnel safety.