Basic operation and programming – Precision Digital PD6310 User Manual
Page 33
Model PD6210 & PD6310 Batch Controllers
Instruction Manual
33
BASIC OPERATION AND PROGRAMMING
The PD6210 is factory calibrated prior to shipment to read in
milliamps and volts depending on the input selection. The
calibration equipment is certified to NIST standards.
The PD6310 has been factory calibrated to read input frequency
in Hz (pulses/sec). The calibration equipment is certified to NIST
standards.
Overview
Most setup and programming is done through the front panel buttons.
The PD6310 has one switch located to the right of the input connector,
which must be configured according to the input level and type. Jumper
J4 located inside the controller, behind the input signal connector, is
used to select the excitation voltage (24 V*, 10 V or 5 V) which is
supplied to the P+ and P- wiring terminals.
After power and input signal connections have been completed and
verified, apply power to the controller.
*Default Setting