Precision Digital PD6310 - Manual (Page 85)

Model PD6210 & PD6310 Batch Controllers Instruction Manual
85
7. The Clone controller displays the message CPY rC while being
programmed then the message done when copying is completed.
The controller initializes and returns to Run Mode using the same
settings as the Master.
8. If controller to be cloned does not respond to the data being sent,
refer to the Copy Function Requirements on page 84.
TROUBLESHOOTING
The rugged design and the user-friendly interface of the controller should
make it unusual for the installer or operator to refer to this section of the
manual. However, due to the many features and functions of the
controller, it’s possible that the setup of the controller does not agree
with what an operator expects to see.
If the controller is not working as expected, refer to the Diagnostics menu
and recommendations below.
Diagnostics Menu (diag)
The Diagnostics menu is located in the Advanced Features menu, to
access Diagnostics menu see ADVANCED OPERATION AND
PROGRAMMING, page 71.
It provides an easy way to view the programmed parameter settings for
troubleshooting purposes. Press the Enter button to view the settings
and the Menu button to exit at any time.
For a description of the diagnostic messages, see Advanced Features
Menu &
Display Messages, page 72.
Determining Software Version
To determine the software version of a controller:
1. Go to the Diagnostics menu (diAG) and press Enter button.
2. Press Up arrow button and scroll to Information menu (Info).
3. Press Enter to access the software number (SFT) and
version (UER) information. Write down the information as it is
displayed. Continue pressing Enter until all the information is
displayed.
4. The controller returns to Run Mode after displaying all the
settings.