Precision Digital PD6310 - Manual (Page 73)

Model PD6210 & PD6310 Batch Controllers Instruction Manual
73
Display Parameter Action/Setting
up Up
Set the total to count up
Douwn Down
Set the total to count down
Gtot C
Grand total
count
Set the grand total to count up or down from a
defined value
C strt Count start
Set the starting grand total value when counting
down
AoutPr Analog output
programming
Program analog output parameters
Source
Source
Select source for the 4-20 mA output
O-rang Overrange
Program mA output for display overrange
u-rang Underrange
Program mA output for display underrange
Break Loop Break
Set relay condition if loop break detected
Force Force output
Force analog output value for loop break
Ignore Ignore
Ignore loop break condition
mAx Maximum
Program maximum mA output allowed
min
Minimum
Program minimum mA output allowed
Calib Calibrate
Calibrate 4-20 mA output (internal reference
source used for scaling the output)
4 mA
4 mA output
Enter mA output value read by milliamp meter
with at least 0.001 mA resolution
20 mA 20 mA output
Enter mA output value read by milliamp meter
with at least 0.001 mA resolution
user User I/O
Assign function keys and digital I/O
F1 F1 function key
Assign F1 function key
F2 F2 function key
Assign F2 function key
F3 F3 function key
Assign F3 function key
F4 F4 function
Assign F4 function (digital input)
dI I Digital input 1
Assign digital input 1 – 8, if expansion modules
are connected
dO 1 Digital output 1
Assign digital output 1 – 8, if expansion
modules are connected
ICal
Internal source
calibration
Enter internal source calibration (used for
scaling the controller without a signal source
C CAL Current
calibration
Calibrating 4-20 mA current input (internal
reference source used for scaling the input)