Precision Digital PD6400 - Manual (Page 84)

Model PD6400 High Voltage & Current Meter Instruction Manual
84
Reset Meter to Factory Defaults
When the parameters have been changed in a way that makes it difficult
to determine what’s happening, it might be better to start the setup
process from the factory defaults.
Instructions to load factory defaults:
1. Enter the Advanced Features menu. See Advanced Features
Menu, page 65.
2. Press Up arrow to go to Diagnostics menu
3. Press and hold Right arrow for three seconds, press
Enter when display flashes reset.
Note: If Enter is not pressed within three seconds, the display
returns to Run Mode.
4. The meter goes through an initialization sequence (similar as on
power-up), and loads the factory default settings.