Remote Processing RPC-210 - Manual (Page 59)

TECHNICAL SPECIFICATIONS SECTION 16
Page 16-2
between the battery and IC under it to keep the battery
from rocking. Bear in mind that the clock and RAM
draw micro-amps of current. Any conduction between
the + and - sides of the battery drains it. Be careful of
chemical adhesives as they may initially draw a lot of
current unit they cure.
Another way ar ound the batter y problem may be to
remov e B1 and solder leads to the battery holes.
Secure the settings for the reference and contrast pots R7
and R16. T hese pots are relatively open, so a high
viscosity fluid should be used.
MOUNTING TO A MOTHER BOARD
The RPC-210 can plug into a "mother board" which has
power, signal and other functions on it. F igure 15-1
shows pin 1 connector locations. Mother board
connectors are dual row, female, on a 0. 1" x 0. 1"
matrix, for 0.025" square posts. A table of
manufacturers and types are listed below.
Manufacturer P/N and size
3M 929852E-01-26 26 position
3M 929852E-01-20 20 position
3M 929852E-01-10 10 position
A M P 2-1734508 26 position
Oupiin 204-126G S PC B mount, 26 pin
Oupiin 204-120G S PC B mount, 20 pin
Oupiin 204-110G S PC B mount, 10 pin
Samtec SSM se ries (sur face mo unt)
Samtec SSW, SSQ series (through hole)
Samtec ESW, ESQ series (elevated)
Samtec connectors come in a variety of plating and
lengths. Contact them at 800-726-8329 for more
information.
M a x im u m co m po n en t h e ig h t i s 0 . 6 0" .
Remote Pr ocessing can, on special order and in quantity,
put connectors on the circuit side of the board.