Roland P-20HD Video Instant Replayer - Manual (Page 15)

15
Video Operations
Recording and Playback
You can play back a previously recorded scene while the P-20HD is recording (chase play).
1 . Press the INPUT [SELECT] button to select the input.
Confirm that the video of the input you selected is shown on this
unit’s display and in the upper left of the monitor connected to
the OUTPUT PREVIEW connector.
* You can make only the necessary input selectable when you press
the INPUT [SELECT] button.
Set the selection to “Enable” or “Disable” for each input in “Input
Select Customize” within the SYSTEM menu.
2 . Press the [REC] button.
Recording on the SD card begins.
After recording begins, the recorded video (replay video) plays back
around one second later on this unit’s display and in the upper right
of the output preview.
MEMO
¹ To stop chase play, press the [ ] button.
¹ To resume playback, press the [ ø ] button.
3 . Hold down the [EXIT] button and press the [REC]
button.
This stops the recording.
Once recording stops, the playback briefly stops as well, but the
unit allows you play back soon afterwards.
NOTE
¹ Never remove the SD card while recording or playing back.
¹ Up to 12 hours of video can be recorded per project.
Recording stops automatically when the recording time
exceeds 12 hours.
Changing the Playback Speed
Use the [SPEED] lever and the [JOG/SHUTTLE] dial to advance
through the frames of the video during playback, or to change the
playback speed.
MEMO
You can also freely play back video data recorded at a past date
and time (scenes that were previously recorded) while recording.
[SPEED] lever
Move the [SPEED] lever back and forth to change the playback speed.
NOTE
The video sound is not played back when you change the playback
speed.
¹ The playback speed always starts at 100% when
you press the [PLAY] button, regardless of the lever
position. After playback begins, the speed changes
according to how you move the [SPEED] lever.
¹ Playback begins when you move the lever from the
0% position while playback is paused.
[JOG/SHUTTLE] dial
Use this dial to switch between jog mode (frame advance) and
shuttle mode (speed change).
* If the [JOG] button and [SHUTTLE] button are both unlit, operating
the dial has no effect.
Jog mode
Press the [JOG] button to enter jog mode (the button lights up).
Pauses the instant you turn the dial, and
advances by frame.
Clockwise Frame advance forward
Counterclockwise Frame advance reverse
There are two operating methods. You can set the frame advance
interval for each operation.
¹ Turn the [JOG/SHUTTLE] dial
Set the frame advance interval in “JOG Speed”, Project Settings
menu (p. 52).
¹ Turn the [JOG/SHUTTLE] dial while holding down the [JOG] button
Set the frame advance interval in “[JOG] + Dial”, Project Settings
menu (p. 52).