Epson 7850p - Manual (Page 126)

126 Using the Projector’s Menus
Adjusting the Image Quality
You can use the Video menu to adjust the brightness, sharpness, color,
tint, and contrast. If you’re projecting from a computer (but not
through the
DVI port), there are additional adjustments you can make
(see page 127).
Adjusting Images from Video Sources
1. Press the Menu button on the remote control, then select the
Video menu.
You see the Video menu screen. (The actual settings may vary,
depending on the selected input source. The Video menu below is
for a composite video or S-video source.)
2. Use the pointer button to highlight the desired option, then
adjust it as needed:
■ Position
If the image is slightly cut off on one or more sides, it may not
be centered exactly. Use this setting to center it (not available
for RGB video images).
■ Brightness
Lightens or darkens the overall image.
■ Contrast
Adjusts the difference between light and dark areas.
Adjust Adjust
+ -
+ -
+ -
+ -
+ -
Video Video
Audio Audio
Setting Setting
User's Logo
User's Logo
Advanced1 Advanced1
Color Mode Color Mode
Position Position
Brightness Brightness
Contrast
Contrast
Color Color
Tint Tint
Sharpness
Sharpness
:
:
:
:
: 0 0
0 0
0 0
0 0
0 0
Select Select [Dynamic ] [Dynamic ]
[Menu]: Exit [Menu]: Exit
Video Signal Video Signal Select Select
[ ]: Enter [ ]: Enter [ ]: Select [ ]: Select
[Auto ] [Auto ] About About
Reset All Reset All
Advanced2 Advanced2
Effect Effect
Reset Reset Execute Execute
note
The Brightness setting
changes the opacity of the
projector’s LCD panels. You
can also change the lamp’s
brightness. Select
Brightness Control in the
Advanced 2 menu, then
choose
High or Low (the
default setting is High ).