Epson 7850p - Manual (Page 29)

Displaying and Adjusting the Image 29
Shutting Down the Projector
When you’ve finished using the projector, follow the recommended
procedure to shut it down. This extends the life of the lamp and
protects the projector from possible overheating.
1. Turn off any equipment plugged into the projector.
2. To turn off the projector, press the red P Power button on the
projector or remote control.
You see a confirmation message. (If you don’t want to turn it off,
press any other button.)
3. Press the Power button again. The power light flashes orange for
about 40 seconds as the projector cools down. After the projector
has cooled, the orange light stays on and the exhaust fan shuts off.
If you want to turn the projector on again, wait until the orange
light stops flashing. Then press the
Power button.
4. If you extended the adjustable front foot, press up on the blue
foot release lever to retract it.
5. Replace the lens cap and unplug the power cord.
6. If you’re using a remote control, set its ON/OFF switch to OFF .
note
When the projector has not
received any input signals
for 30 minutes, it
automatically turns off the
projector lamp and enters
“sleep mode.” This conserves
electricity, cools the
projector, and extends the
life of the lamp. If you want
to start projecting again,
press the
Power button. If
you are done using the
projector, unplug the power
cord. To turn off sleep mode,
see page 139.
Power button
Power OFF? Power OFF?
Yes Yes : : Press button Press button
No No : : Press any other button Press any other button
caution
To avoid damaging the
projector or lamp, never
unplug the power cord when
the power light is green or
flashing orange.