Epson 7850p - Manual (Page 135)

Using the Projector’s Menus 135
Controlling Multiple Projectors
If you’re using more than one projector for your presentation, you can
use the projector’s ID system to switch between them using a single
remote control. To do this, you need to set a different ID for each
projector. During the presentation, it’s easy to change the remote
control’s ID to match that of the projector you want to use. When
you want to switch, simply change the remote control’s ID to match
that of your second projector.
Setting the Projector ID
The projector’s default ID is 1. Follow these steps to change it:
1. Press the Menu button on the remote control.
You see the projector’s menu screen.
2. Select the Advanced2 menu and press Enter . Then highlight
Projector ID and press Enter .
3. Press the right or left side of the pointer button to increase or
decrease the ID value.
4. Press Enter to set the value.
5. When done, press E SC to exit the menu system.
note
By default, the remote
control’s ID is set to zero,
which allows it to control
any projector. If you want to
control multiple projectors
simultaneously, and you
don’t want to switch
between them (each
projector would need its own
screen), you can leave the
remote control’s ID set to
zero. In this situation, you
would not need to change
the projector’s ID.
Brightness Control Brightness Control High High Low Low : Video Video
Audio Audio
Setting Setting
User's Logo User's Logo
Advanced1 Advanced1
About About
Reset All Reset All
Projector ID Projector ID
Network Network
Reset Reset Execute Execute
: 1 : 1
[Menu]: Exit [Menu]: Exit
Effect Effect
Advanced2 Advanced2
COM Port COM Port
BNC Sync Termination BNC Sync Termination
:
ON ON OFF OFF :
Set Set
Set Set
RS-232C RS-232C USB USB
[ / ]: Select [ / ]: Select [ ESC ]: Return [ ESC ]: Return [ ]: Set [ ]: Set
Auto setup Auto setup : OFF OFF : ON ON