Epson 7850p - Manual (Page 18)

18 Displaying and Adjusting the Image
Projecting the Image
Make sure your projector and other equipment are set up as described
in Chapter 3. Then follow the instructions below to start the projector
and display an image.
Turning on the Projector
If you turn on any connected computer or video equipment before
starting the projector, this lets the projector automatically detect and
display the image source. If you turn on the projector first, or have
multiple pieces of connected equipment, you may have to select the
image source manually (see page 20).
Follow these steps to turn on the projector:
1. Remove the lens cap.
2. Plug one end of the power cable into the projector, and the other
end into a grounded electrical outlet.
3. Wait until the Ppower light stops flashing and turns orange.
note
To shut down the projector,
see page 29. Shutting down
the projector correctly
prevents premature lamp
failure and possible damage
from overheating.
Power light