Epson 7850p - Manual (Page 136)

136 Using the Projector’s Menus
Changing the Remote Control ID
To change the remote control’s ID to match that of a projector, follow
these steps:
1. Press the ID button on the remote control. You see it light.
2. Press one of the numbered buttons on the remote control to select
the ID of the projector you want to operate.
The ID button’s light shuts off and the new ID is registered.
3. Repeat steps 1 and 2 each time you want to switch projectors.
To check the remote control’s current ID, do the following:
1. Press the ID button twice in succession. After a moment, the
button flashes.
2. Count the number of flashes; this number corresponds to the
remote control’s ID. (If it doesn’t flash, the ID is set to zero.)
Zero